Sounds and Video!

 

Here are a few wav's of my Camaro when it had the 305 and TBI injection. The exhaust consisted of edelbrock TES headers, 3" highflow cat, and 3" borla. I just love the deep sound.

This is me reving a little. Sounds gooooooood!

Here is me taking off and going through 1^st and 2^nd gears. You can hear me spin a little off the line and then when I shift into 2^nd.

Here is some video(MPG format) shot on August 6th, 1999 at State Capitol Dragway. This is on the same night when I broke into the 12's using the fun juice on the old 305 with TPI. The exhaust conisted of SLP Tri-Y headers and 3" Borla. Enjoy!! (Just click on the play button below to start downloading)

This is me doing my burnout. As you'll see it is nothing spectacular. I just bring the revs up several times and roll forward. That's pretty much all you need with drag radials.

Here is a pass where I went a 13.07. I wish you could see the ET board!! I killed the 1st gen camaro next to me. I think he went a 13.89.

Here are some latest videos(MPG format) with my current 355 setup. I went a 12.07 on this particular run. The exhaust consists of Hooker 1-3/4" long tube headers, custom 3" y-pipe and 3.5" Mufflex single exit system with the Spintech muffler. (Just click on the play button below to start downloading)

Here is the burnout before I stage. I usually just spin them over a few seconds and when I start to see smoke I let off the brake and roll forward. (About 2.4megs)

So close to the 11's on this run. Doesn't look like I left hard but I pulled a 1.78 60'. The truck next to me lighted and out 60 footed me...but I still beat him though! (About 2.8megs)

BACK